Sorento 4WD V6-3.8L (2009)
3. Connect the clock spring harness connector and horn harness connector to the clock spring.
4. Install the clock spring with 4 screws.
5. Set the center position by getting marks between the clock spring and the cover into line. Make an array the mark (><) by turning the clock spring
clockwise to the stop and then 2.4 revolutions counterclockwise.
6. Install the steering wheel column cover and the steering wheel.
7. Connect the Driver Airbag (DAB) module connector and horn connector, then install the Driver Airbag (DAB) module on the steering wheel.
8. Secure the Driver Airbag (DAB) with the new mounting bolts.
Tightening torque (DAB Mounting Bolt)
: 0.8 - 1.1 kgf.m (7.9 - 10.8 Nm, 5.8 - 8.0 lb.ft)
9. Connect the battery negative cable.
10. After installing the airbag, confirm proper system operation:
A. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
B. Make sure horn button works
Components and Components Location
COMPONENTS
Repair Procedures
REMOVAL
1. Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
2. Remove the following parts.
A. Crash pad lower panel
