Sorento 4WD V6-3.8L (2009)
-
When adjustment is impossible, replace the side gear and the pinion gear as a set.
7. INSTALLATION OF THE LOCK PIN
(1) Align the pinion shaft lock pin hole with the differential case lock pin hole, and drive in the lock pin.
(2) Fix the lock pin in place by staking two points around the lock pin hole with a punch.
8. INSTALLATION OF THE DRIVE GEAR
(1) Clean the drive gear attaching bolts.
(2) Remove the adhesive on the threaded holes of the drive gear use a tap (M10 x 1.25), and then clean the threaded holes with compressed air.
(3) Apply the specified adhesive to the threaded holes of the drive gear.
Specified adhesive : LOCTITE #262 or equivalent
(4) Install the drive gear in the differential case with the matchmarks properly aligned. Tighten the bolts to the specified torque in a diagonal
sequence.
9. PRESS THE SIDE BEARING INNER RACE
10. Attach actuator at differential case RH side as figure
CAUTION:
Take heed of actuator direction.