Soul L4-2.0L (2010)
Enter the vehicle information by pressing the VIN Auto Detect button, entering the vehicle's VIN or selecting the vehicle model, model year, engine/fuel
type and A/T as the system; then click OK.
6. Once back at the GDS Main Screen, select ECU Upgrade, then select Auto Mode, and then AlT in the left ECU Upgrade column, then perform the
ECU upgrade in accordance with normal GDS tool ECU upgrade procedures. Complete steps 5 to 8 as outlined in the Manual Upgrade procedure below.
MANUAL UPGRADE PROCEDURE
NOTICE
Do NOT attempt to perform a Manual Mode upgrade unless Auto Mode fails. Always follow the instructions given on the GDS tool in either Auto or
manual mode. See table for Manual Mode passwords.
Do NOT Force the Calibration into the Incorrect P/N ECU, this is subject to warranty chargeback.
1. Within the ECU Upgrade screen, select Manual Mode in the left column, then select the appropriate #143 UPDATE. Select the appropriate control
unit part number with reference to the ROM ID Information Table and click Upgrade.
2. Enter the appropriate password from the table below, and then click OK.
MANUAL MODE PCM UPGRADE PASSWORDS:
2. Upgrade will begin and the progress of the upgrade will appear on the bar graph.
Upgrade will occur until 100% is reached on the bar graph. Turn the ignition key OFF for 20 seconds, place it back in the ON position and then click OK
to continue according to Information displayed on the screen.
4. Click OK on the final screen, which indicates upgrade is complete.
5. After upgrade is complete, reset the TCM adaptive learning values, using GDS.
6. After resetting the previously learnt values, perform "static test" by changing gears to "R", "N" and "D" from "P" and back to "P" with 5-second
intervals at each gear. Perform this 4-5 times.
7. Next, perform the dynamic relearn procedure by driving the vehicle on a flat surface from 1st gear to 4th gear and vice versa with TPS input in the
