Soul L4-2.0L (2010)
ROM Table Information
NOTICE
To verify the vehicle is affected, be sure to check the Calibration Identification of the vehicle's ECU's ROM ID and reference the Information Table as
necessary.
1. Connect the power supply cable to the GDS tool.
NOTICE
If attempting to perform the ECU upgrade with the power supply cable disconnected from the GDS tool, be sure to check that the GDS tool is fully
charged before ECU upgrade. If the GDS tool is not fully charged, failure to preform the ECU upgrade may occur. Therefore, it is strongly
recommended that the power supply connector be connected to the GDS tool.
2. Connect the USB cable between the VCI and the GDS tool.
3. Connect the Main 16-pin DLC cable (GHDM - 241000) to the OBD-II connector, located under the driver's side of the instrument panel.
4. Turn on the VCI and diagnostic terminal with the ignition key in the ON position.
*NOTICE
Do not start the engine.
AUTOMATIC UPGRADE PROCEDURE
5. Choose VIN or ECU Upgrade on the initial screen.