Spectra5 L4-2.0L (2005)
Air Bag(s) Arming and Disarming: Service and Repair
PRECAUTIONS AND PROCEDURES
Please read the following precautions carefully before performing the airbag system service. Observe the instructions described, or the airbags could
accidentally deploy and cause damage or injuries.
1. Except when performing electrical inspections, always turn the ignition switch OFF and disconnect the negative cable from the battery, and wait at
least three minutes before beginning work.
NOTE: The contents in the memory is not erased even if the ignition switch is turned OFF or the battery cables are disconnected from the battery.
2. Use the replacement parts which are manufactured to the same standards as the original parts and quality. Do not install used SRS parts from
another vehicle. Use only new parts when making SRS repairs.
3. Carefully inspect any SRS part before you install it.
Do not install any part that shows signs of being dropped or improperly handled, such as dents, cracks or deformation.
4. Before removing any of the SRS parts (including the disconnection of the connectors), always disconnect the SRS connector.
AIRBAG HANDLING AND STORAGE
Do not disassemble the airbags. It has no serviceable parts. Once an airbag has been deployed, it cannot be repaired or reused.
For temporary storage of the air bag during service, please observe the following precautions.
1. Store the removed airbag with the pad surface up.
2. Never twist the Curtain Airbag (CAB) module.
