Spectra5 L4-2.0L (2005)
5.
Remove the connector from the bracket. Be very careful not to damage the connector attaching clip. The connector must be secured after repair for
proper oxygen sensor operation.
6.
Remove the back cover from the connector by lifting the two tabs shown.
7.
Peel the tape off the connector wiring harness back three or four inches.
8.
Remove the white plastic terminal retainer from the connector.
9.
Remove the two terminals # 1 (Blue with orange stripe) and # 4 (White) using a two blade terminal removal tool. Locations of terminals 1 and 4
are shown in the picture above.
Recommended terminal removal tools are:
Blue-Point P/N-TT1212 from kit P/N-TT12KT.
MAC Tools P/N-TT93060 (same as Blue-Point tool) from kit P/N-TT96030 (shown above)
*NOTICE:
