Spectra5 L4-2.0L (2005)
On vehicles with inner and outer bearings, inspect the bearings and races for wear or damage. Adjust or install new bearing and races as necessary.
4. Check the hub for cracks and the splines for wear.
5. Check the brake disc for scoring and damage.
6. Check the knuckle for cracks.
7. Check the bearing for cracks or damage.
REASSEMBLY
1. Apply multi-purpose grease to the contacting surface of the knuckle hub and bearing thinly.
2. Using the Special Tool (09532-11500), press-in the bearing to the knuckle.
A. Install the snap ring.
NOTE:
1) Press-in the outer race of the wheel bearing to prevent damage to the bearing assembly.
2) When installing a bearing assembly, always use a new one.
3) The right and the left bearings must be replaced as a matched set.
3. Using a plastic hammer, install the dust cover.
4. Press-in the hub to the knuckle.
NOTE: Press-in the inner race of the wheel bearing to prevent damage to the bearing assembly.
5. Tighten the hub and the knuckle to the specified torque using the Special Tool (09517-21500).
Specified torque Nm (kg-cm, lb-ft) 200 - 250 (2000 - 2500, 147 - 184)
6. Measure the hub bearing starting torque.
Hub bearing starting torque [Limit] 1.8 Nm (18 kg-cm, 1.3 lb-ft) or less
