Spectra5 L4-2.0L (2005)
Clutch Disc: Testing and Inspection
Clutch Cover And Disc
INSPECTION
Clutch cover assembly
1. Check the diaphragm spring end for wear and uneven height.
2. Check the pressure plate surface for wear, cracks and color change.
3. Check the rivets for looseness and replace the clutch cover assembly if necessary.
Clutch disc
1. Check the clutch facing for loose rivets, uneven contact, deterioration due to seizure, adhesion of oil, or grease, and replace the clutch disc if
defective.
2. Measure the thickness of the disc when free.
3. Check for the torsion spring play and damage and if defective, replace the clutch disc.
4. Clean the splines on the input shaft and install the clutch disc.
If the disc does not slide smoothly or if play is excessive, replace the clutch disc and/or the input shaft.
Clutch release bearing
CAUTION: The release bearing is packed with grease. Do not use cleaning solvent or oil.
1. Check the bearing for seizure, damage or abnormal noise. Also check the diaphragm spring contacting points for wear.
2. Replace the bearing if the release fork contacting points are worn abnormally.
Clutch release fork
If there is abnormal wear at the point of contact with the bearing, replace the release fork assembly.
