Spectra5 L4-2.0L (2005)
7. Loosen the bolts which attach the clutch cover to the flywheel in a star pattern. Loosen the bolts in succession, one or two turns at a time, to avoid
bending the cover.
NOTE: Do not clean the clutch disc or the release bearing with cleaning solvent.
8. Remove the release fork shaft and bushing.
Installation
1. Apply multipurpose grease to the spline of the disc.
Grease: CASMOLY L 9508
CAUTION: When installing the clutch, apply grease to each part, but be careful not to apply excessive grease. It can cause clutch
slippage and vibration (shudder).
2. Install the clutch disc assembly to the flywheel using the special tool (09411-25000).
3. Install the clutch cover assembly to the flywheel and temporarily tighten the bolts one or two steps at a time in a star pattern.
Tightening Torque Clutch cover bolt: 15 - 22 Nm (150-220 kg-cm, 10-16 lb-ft)
4. Align the bearing (A) to the release fork (B) and then install it to the sleeve of the housing.
CAUTION: Apply multipurpose grease (CASMOLY L9508) to the bearing sleeve and contact point of the release fork.
5. Install the release lever to the release fork.
