Spectra GS L4-1.8L (2002)
Brake Light Bulb: Service and Repair
4 DOOR
Rear combination light assembly bulb Replacement
1. Disconnect negative battery cable.
2. Disconnect electrical connector from light assembly.
3. Remove two mounting screws and two nuts from combination light assembly.
4. With bulb holder disengaged, pull bulb holder carefully forward relative to vehicle, and remove from light assembly.
5. Remove bulb as required from bulb holder.
6. Install new bulb of proper type, as shown on bulb holder.
7. Position bulb holder on light assembly and press to engage with light assembly.
8. Install combination light assembly by positioning slightly toward outside of vehicle and sliding inward into position.
9. Install two mounting screws and two nuts.
10. Install electrical connector.
11. Connect negative battery cable.
