Sportage 2WD L4-2.0L (1997)
2. Remove the retainer plate and then remove the clutch discs and clutch plates.
3. Using SST K95B-4200 AT3 and an hydraulic press, compress the eighteen direct clutch piston return springs and remove the retaining ring, return
spring seat, and the return springs.
NOTICE: Be careful when applying pressure, for overpressure will cause the plate section of the piston return spring to deform.
4. Install the direct clutch cylinder onto the center support. Remove the direct clutch outer piston by blowing air at 30 psi (5.3 kg/cm2) into the
second hole from the left as shown.
5. Remove the direct clutch inner piston by blowing air into the hole at the extreme right.
6. Remove the O-rings from the pistons.
INSPECTION
