Sportage 2WD L4-2.0L DOHC (1996)
Rear Door Window Regulator: Service and Repair
Notice: There is no stand alone Rear Door Window Regulator article authored by the manufacturer. This information was extracted from the Rear Door
Removal article.
Rear Door Window Regulator Removal and Installation
1. Remove inner glass weatherstrip.
2. Remove the door trim.
3. Remove two screws on the pull handle bracket.
4. Peel off the plastic door screen carefully by pulling it away gradually from the door frame.
5. Remove window glass:
a. Reconnect window operating switch.
b. Connect negative battery cable.
c. Turn on the ignition and position the window glass about halfway.
d. Turn off the ignition.
e. Remove one screw and one bolt on the quarter glass channel.
