Sportage 2WD L4-2.0L SOHC (1995)
Electronic Brake Control Module: Service and Repair
NOTE: On models equipped with airbag system, refer to Technician Safety Information for system disarming and arming procedures.
Fig. 17 ABS Control Unit Replacement
1. Disconnect battery ground cable.
2. Disconnect ABS control unit harness connector.
3. Remove lower instrument panel trim panel below steering column. Trim panel screws are accessed by removing two square screw covers.
4. Remove three ABS control unit mounting screws, Fig. 17.
5. Remove ABS control unit.
6. Reverse procedure to install.
7. On models equipped with airbag system, refer to Technician Safety Information for system disarming and arming procedures.
