Sportage 2WD L4-2.0L SOHC (1995)
Fuel Pressure: Testing and Inspection
Fuel Pump Maximum Pressure
Test
DLC Connector View
FUEL PUMP MAXIMUM PRESSURE
1. Disconnect the negative battery terminal.
2. Perform the Fuel Pressure Release Procedure
3. Connect a fuel pressure gauge to the fuel filter and plug the outlet of the gauge as shown. (Install clamps as shown.)
4. Connect the negative battery terminal.
5. Connect the data link connector terminals FUEL PUMP and B+ with a jumper wire.
6. Turn the ignition switch on to run the fuel pump.
7. Measure the fuel pump maximum pressure.
Fuel pump maxinium pressure: above 50 psi (340 kPa)
8. Turn the ignition switch off and take off the jumper wire.
9. If this pressure is not measured, replace the fuel pump.
