Sportage 2WD L4-2.0L SOHC (1995)
Throttle Position Sensor: Testing and Inspection
Connector
Spec Chart
Resistance Vs Throttle Angle
RESISTANCE INSPECTION
1. Disconnect the connector from the throttle position sensor.
2. Connect an ohmmeter between the sensor terminals B and C.
3. Verify that the resistance increases linearly according to the throttle angle.
4. If the resistance is not as specified, replace the sensor.
5. Connect the sensor connector.
6. Perform the throttle inspection procedure for the throttle position sensor after installation of a new one.
Spec Chart
