Sportage 2WD V6-2.7L (2009)
Brake Pedal Assy: Service and Repair
Repair Procedures
INSPECTION
1. Check the bushing for wear.
2. Check the brake pedal for bending or twisting.
3. Check the brake pedal return spring for damage.
4. Check the stop lamp switch
(1) Connect a circuit tester to the connector (1-2terminals) of stop lamp switch, and check whether or not there is continuity when the plunger of
the stop lamp switch is pushed in and when it is released.
(2) The stop lamp switch is in good condition if there is no continuity when plunger is pushed.
REMOVAL
1. Remove the lower crash pad.
2. Pull down steering column shaft after removing 4 bolts.
3. Remove the stop lamp switch connector (A).
4. Remove the shift lock cable (A/T).
5. Remove the pin and snap pin.
6. Loosen the brake pedal member assembly mounting nuts and then remove the brake pedal assembly.
INSTALLATION
1. Installation is the reverse of removal.
CAUTION:
Coat the inner surface of the bushings with the specified grease.
Specified grease:Chassis grease MS 511-3
2. Before inserting the pin, apply the specified grease to the joint pin.
