Sportage 2WD V6-2.7L (2009)
Coolant Temperature Sensor / Switch HVAC: Service and Repair
Replacement
REPLACEMENT
1. Disconnect the negative(-) battery terminal.
2. Remove the passenger's center lower side cover(A) .
3. Disconnect the connector(A) of water temperature sensor.
4. Remove the caulk of water temperature sensor by using the scraper.
5. Pull the water temperature sensor out at the heater unit with the clamp(C).
NOTE:
Take care that wire of water temperature sensor is not to be damaged
6. Install in the reverse order of removal.
NOTE:
-
Apply caulk to the water temperature sensor.
-
Make sure that there is no air leakage.