Sportage 2WD V6-2.7L (2009)
13. Place a Screw Jack under the rear of the subframe.
14. Remove the 2 bolts holding the rear of the subframe to the
vehicle.
15. With the Screw Jack, lower the rear of the subframe to get at
least 1 inch of clearance between the subframe and the body peg.
Remove the Upper Stopper.
Proceed to Removing The Subframe Bushing procedure.
Afterwards, if replacing the front bushings, loosely install rear
bushing bolts and remove corner stays and front bushing bolts.
Service Procedure Removing The Subframe Bushing