Sportage 2WD V6-2.7L (2009)
Tire Pressure Sensor: Procedures
Sensor Initiating Procedure
NOTE:
The sensor's default state will be Storage Auto (High Line).
1. Change the sensor mode to Normal Fixed Base(Low Line) with the 'TPMS exciter'.
2. Read the four sensor's ids starting with sensor 1 (1 normally front left, 2 front right, 3 rear left, 4 rear right).
NOTE:
Note that sensors which were already configured as Base (Low Line) will take longer to read.
3. Connect 'TPMS exciter' to the diagnostic connector.