Sportage 2WD 2Dr L4-2.0L (2002)
39. Clean the gasket mating surfaces.
Installation
1. Install and tighten two bolts for the pressure regulator.
2. Install and tighten the pulsation damper.
3. Install two injector insulators.
4. Install the fuel rail to the injectors.
5. Install the four injector fuel rail clips.
6. Install the two bolts to the fuel rail and tighten.
7. Connect the fuel hose to the pressure regulator.
8. Connect the fuel hose to the fuel rail.
9. Position the dynamic chamber gasket.
10. Install the dynamic chamber.
11. Install and tighten the three nuts and bolts for the dynamic chamber.
12. Install the vacuum hose to the vacuum pipe.
13. Install the heater inlet hose at the elbow.
14. Install the bottom bolt to the idle air control valve bracket.
15. Connect the electrical connector to the idle air control valve.
16. Connect the hose for the idle air control valve.
17. Install the clamp and hose to the air rail.
18. Install the two top bolts with the manifold bracket. Do not tighten the bolts at this time.
19. Raise the vehicle on a lift.
20. Install and tighten the two bottom bolts on the manifold bracket.
21. Lower the vehicle.
22. Tighten the two top bolts on the manifold bracket.
23. Install the two bolts and brackets to the dynamic chamber.
24. Install the cruise control vacuum hose to the dynamic chamber.
25. Connect the two coolant hoses to the throttle body.
26. Connect the vacuum hose from the intake manifold to the vacuum pipe.
27. Connect the throttle position sensor electrical connector.
28. Connect the brake booster vacuum line to the dynamic chamber connector.
29. Install the air intake hose assembly.
30. Install and tighten the one bolt for the air intake hose bracket.
31. Install the bolts for the mass air flow sensor bracket and tighten.
32. Connect the mass air flow sensor electrical connector.
33. Tighten the air intake hose clamp at the air cleaner.
34. Tighten the air intake hose clamp at the throttle body
35. Connect the accelerator cable.
