Sportage 2WD 2Dr L4-2.0L (2002)
1. Raise the vehicle on a hydraulic lift to a level where access can be gained at the right rear wheel well area.
2. Install the inlet pipe assembly and the attaching bolt holding the inlet pipe assembly to the vapor separator assembly.
3. Connect the inlet pipe assembly/vapor separator assembly to the hose-joint and the fuel hose. Install the two clamps.
4. Install the attaching bolts to the bracket holding the inlet pipe assembly to the vehicle frame.
5. Install the nut to the attaching bracket for the neck portion of the inlet pipe assembly.
6. Lower the vehicle on the hydraulic lift to ground level. Install three screws to the neck portion of the inlet pipe assembly.
7. Install the filler cap to the threaded portion of the inlet pipe assembly.
8. Close the fuel inlet filler door by pushing it until the catch is secure.