Sportage 2WD 4Dr L4-2.0L (2000)
Tightening torque: 14 - 18 ft. lbs. (19 - 25 Nm)
10. Install the two dynamic chamber support brackets bolts and tighten to specification.
Tightening torque: 14 - 18 ft. lbs. (19 - 25 Nm)
11. Install the purge solenoid valve vacuum hose to the intake manifold.
12. Install the vacuum hose to the fuel pressure regulator.
13. Install the two coolant hoses under the throttle body.
14. Reconnect the electrical connection to the idle air control valve.
15. Install the brake booster vacuum hose.
16. Install the heater hoses.
17. Reconnect the electrical connector to the throttle position sensor.
18. Install the purge solenoid valve vacuum hose to the dynamic chamber.
19. Install the air intake tube and air intake hose as an assembly to the throttle body with three bolts and tighten to specification.
Tightening torque: 16 ft. lbs. (22 Nm)
20. Install the PCV hose to the dynamic chamber.
21. Attach the accelerator cable to the throttle body pulley.
22. Secure the accelerator cable bracket to the cylinder head cover with two bolts and tighten to specification.
Tightening torque: 10 ft. lbs. (14 Nm)
23. Attach the air intake hose to the MAP sensor and tighten the clamp.
24. Install the resonance chamber, two clamps and one bolt to the air intake tube.
25. Connect the IAC hose, the breather hose and the vacuum line to the intake manifold assembly.
26. Pressurize the fuel system. Refer to Fuel System.
27. Refill the radiator.
28. Connect the negative battery cable.
