Sportage 2WD 4Dr L4-2.0L (2000)
Fig. 13 Blower Unit Removal
9. Detach the blower unit from the vehicle.
Installation
1. Clear the mounting area of any wiring, connectors or cables.
2. Guide the evaporator core tubes through the bulkhead and mount the blower housing unit by inserting two mounting bolts at the top of the unit.
3. Loosely install two nuts on the mounting studs at the bottom of the blower housing unit.
4. Insert two mounting bolts at the top of the blower housing unit.
NOTE: Over-tightening may cause the fresh air/recirculation door to bind.
5. Tighten the nuts and bolts to retain the blower housing unit to the bulkhead.
Tighten the nuts and bolts to 80 lb-in (9 N.m).
6. Install the cover in place.
