Sportage 2WD 4Dr L4-2.0L (2000)
3. Holding the fuel pump assembly, guide it into the access port on the top of the fuel tank as far as it will go at that point.
NOTE: Do not force fuel pump assembly parts. The fuel screen is delicate and can be damaged by improper removal from the tank.
4. While twisting very carefully, and tilting the fuel pump assembly, push gradually until the assembly seats in the fuel tank correctly.
5. Install eight retaining screws around the top surface of the fuel pump assembly.
6. Connect the two fuel hoses to the fuel pump assembly.
7. Install the two fuel hose clamps to the two fuel hoses connected to the fuel pump assembly.
8. Connect fuel tank pressure sensor electrical connector.
9. Insert the ground wire in the fuel pump assembly connector assembly through the access hole in the access cover.
10. Install the four retaining screws attaching the access cover to the flooring of the vehicle.
11. Attach the ground wire lug to the flooring of the vehicle with the attaching screw.
12. Connect the two halves of the fuel pump assembly electrical connector.
13. Place the adhesive tape over the loose wiring and put the square of carpeting back over the area of the access door behind the rear seat.
14. Release the catch for the rear seat and tilt it out of the way.
15. Close the rear access door of the vehicle.
