Sportage 2WD 4Dr L4-2.0L (2000)
EGI Main Relay: Testing and Inspection
MAIN RELAY
Inspection of Terminal Voltage
1. Remove the cover from the main fuse block.
2. Place a finger on the main relay.
3. Verify that the relay clicks when the ignition switch is turned ON.
4. Verify that the main relay clicks when the ignition switch is turned OFF
5. Remove the relay.
6. Apply battery voltage (B+) to terminal 86 and ground terminal 85 of the relay.
7. Check the continuity of the relay as shown.
8. If not as specified, replace the main relay.
9. Turn ignition switch OFF.
10. Install the relay.
11. Replace the cover on the main fuse block.
