Sportage 2WD 4Dr L4-2.0L (2000)
Purge Solenoid Control Solenoid: Testing and Inspection
Evaporative Emission (EVAP) Purge Solenoid Valve
Inspection
1. Disconnect the vacuum hoses from the purge control solenoid valve.
2. Verify that no air flows through the valve.
3. Disconnect the valve connector and apply 12 volt battery voltage as shown in the figure.
4. Verify that air flows through the valve.
5. If no air flows, replace the valve.
6. Reinstall the valve connector.
7. Reconnect the vacuum hoses onto the purge control solenoid valve.