Sportage 2WD 4Dr L4-2.0L (2000)
Power Window Switch: Service and Repair
Power Window Operating Switch
Removal
CAUTION: When a removing or installing any electrical units, wiring or electrical connectors, disconnect the negative battery cable to prevent
possible short circuits which could lead to personal injury and/or property damage.
1. Disconnect negative battery cable.
Power Window Operating Switch
2. Remove switch assembly from door armrest.
a. Remove the screw cap and the screw at the bottom of the door armrest pocket and remove the pocket.
b. Place fingers through armrest access hole and release power window operating switch.
c. Remove the power window operating switch and disconnect the power window harness connector.
Installation
1. Install the power window switch on the door armrest.
a. Pull out the power window harness connector through door armrest access hole and connect the power window harness connector to the power
window operating switch.
b. Set the power window operating switch into the armrest cavity and snap the switch assembly into place.
2. Place the armrest pocket into the armrest access hole and replace the screw and screw cap.
3. Connect negative battery cable.
