Sportage 2WD 4Dr L4-2.0L (2000)
3. Connect pressure hose to damping pipe and install bolt attaching hose to chassis.
Tighten flare fitting to 29 ft. lbs. (39 Nm).
4. Connect pressure hose to power steering pump with nut.
Tighten nut to 14 ft. lbs. (1g Nm).
5. Install pipe assembly No. 4 in top of steering gear.
Tighten to 29 ft. lbs. (39 Nm).
6. Connect return hose No. 1 to pipe assembly No. 4 (steering gear) and return port of reserve tank with clamp at each end.
7. Connect suction hose No. 2 to outlet port of reserve tank and pipe assembly No. 2 with clamp at each end.
NOTE: Do not operate engine before adding power steering fluid as required to fill the system. Operation of the power steering pump with
inadequate power steering fluid will result in damage to the power steering pump.
8. Bleed air from the system.
9. Install under cover with four bolts.
Tighten bolts to 18 ft. lbs. (25 Nm).
