Sportage 2WD 4Dr L4-2.0L (2000)
2. Remove the excess sealant and foam dam from the body with a knife.
3. Clean the inside of the glass with commercial glass cleaner and a lint-free cloth.
4. Prime an area approximately 3/4 in (19 mm) wide around the complete perimeter of the glass. The primer should be Essex U401 or equivalent.
5. Prime the contact area on the body with Essex U413 or equivalent.
6. Reprime the same area on the inside surface of the glass with Essex 402 or equivalent.
Do not permit any primed surface to become contaminated with dirt, water, oil, etc. Do not touch primed surfaces with your hands. Contamination
will affect adhesion.
7. Install the self-adhesive foam dam to the body where the original dam had been.
