Sportage 4WD L4-2.0L (2005)
NOTE:
a. Indicated two identification color marks on the coil spring one follows model option the other follows load classification.
Pay attention to distinguish between the two marks and then install them.
b. Install the coil spring with the identification mark directed toward the knuckle.
3. After fully extending the piston rod, install the spring upper seat and insulator assembly.
4. After seating the upper and lower ends of the coil spring (A) in the upper and lower spring seat grooves (B) correctly, tighten new self-locking nut
temporarily.
5. Remove the special tool (09546-26000).
6. Tighten the self-locking nut to the specified torque.
Tightening torque: 60 - 70 Nm (6 - 7 kgf-cm, 44.3 - 51.6 ft. lbs.)
7. Apply grease to the strut upper bearing and install the insulator cap.
CAUTION: When applying the grease, be careful so that it isn't smeared on the Insulator rubber.
Disposal
FRONT STRUT ASSEMBLY
