Sportage 4WD L4-2.0L (2005)
9. Insert a pry bar (A) between the transaxle case (B) and joint case (C), and separate the driveshaft (D) from the transaxle case.
CAUTION:
^
Use a pry bar (A) being careful not to damage the transaxle and joint.
^
Do not Insert the pry bar (A) too deep, as this may cause damage to the oil seal. (Max. depth 7 mm (0.28 inch)
^
Do not pull the driveshaft by excessive force it may cause components Inside the axle shaft joint kit to dislodge resulting in a torn boot or a
damaged bearing.
^
Plug the hole of the transaxle case with the oil seal cap to prevent contamination.
^
Support the driveshaft property.
^
Replace the retainer ring whenever the driveshaft Is removed from the transaxle case.
Inspection
FRONT DRIVESHAFT ASSEMBLY
