Sportage 4WD L4-2.0L (2005)
INSTALLATION
1. Apply gear oil on the driveshaft oil seal case contacting surface (B) and transaxle case splines (A).
[2WD]
[4WD]
2. Before installing the driveshaft (C), set the opening side of the circlip (D) facing downward.
3. After installation, check that the driveshaft cannot be removed by hand.
4. Install the drive shaft into the knuckle.
5. Install the lower arm mounting bolts (A).
Tightening torque: 100 - 120 Nm (10 - 12 kgf-cm, 73.8 - 88.5 ft. lbs.)
