Sportage 4WD L4-2.0L (2005)
1. Apply gear oil on the driveshaft differential case (B) contacting surface (B) and driveshaft (A) splines.
2. Before installing the driveshaft (A), set the opening side of the circlip facing downward.
3. After installation, check that the driveshaft (A) cannot be removed by hand.
4. Install the BJ into the knuckle.
5. Install the suspension arm mounting nuts (C) and trailing arm mounting bolt (B) from the knuckle (B).
Tightening torque:
Suspension arm mounting nuts (C) 140 - 160 Nm (14 - 16 kgf-cm, 103.8 - 118 ft. lbs.)
Trailing arm mounting bolt (B) 100 - 120 Nm (10 - 12 kgf-cm, 73.8 - 88.5 ft. lbs.)
6. Install the washer (C), castle nut (B) and split pin (A) from the rear hub.
