Sportage 4WD L4-2.0L SOHC (1995)
Brake Master Cylinder: Service and Repair
Removal and Installation
1. Place cloth under master cylinder to prevent brake fluid from falling on painted surfaces.
2. Disconnect clutch fluid hose from back of clutch master cylinder reservoir and drain reservoir.
3. Disconnect fluid level and differential sensor connector.
4. Disconnect brake lines from master cylinder to proportioning valve using line wrench.
5. Disconnect rear wheel brake line from right side of ABS solenoids using line wrench.
6. Disconnect front wheel brake line from lower left port of proportioning valve using line wrench.
7. Disconnect ABS wire harness connector.
8. Disconnect proportioning valve wire harness connector.
9. Remove master cylinder mounting nuts.
10. Remove bracket holding ABS solenoids and proportioning valve.
Fig. 2 Master Cylinder Removal
11. Remove master cylinder from vacuum booster, Fig. 2.
12. Reverse procedure to install. Tighten lines and nuts to specifications.
