Sportage 4WD L4-2.0L SOHC (1995)
Cylinder Head Cover: Service and Repair
NOTE: On models equipped with airbag system, refer to Technician Safety Information for system disarming and arming procedures.
1. Disconnect battery ground cable.
2. Remove accelerator cable and air intake hose mounting bolts from cylinder head cover.
3. Disconnect accelerator cable by pulling back on throttle shaft and place aside.
Fig. 5 Air Intake Assembly
4. Remove air hose, ISC air hose, breather hose and vacuum line from air intake hose, Fig. 5.
5. Disconnect MAF sensor by pushing on wire clip.
6. Remove air hose mounting bolt from air intake housing.
7. Loosen air intake hose clamps at throttle body and air intake housing.
8. Remove air intake hose.
9. Remove PCV valve from valve cover.
10. Remove ISC air hose from idle speed actuator.
11. Remove air hose from behind intake manifold.
