Sportage 4WD L4-2.0L SOHC (1995)
Idle Speed/Throttle Actuator - Electronic: Service and Repair
REMOVAL
1. Check that the ignition key is in the "OFF" position.
2. Disconnect the electrical connector at the idle speed controller.
3. Remove the hose from the intake duct to the idle speed controller.
4. Remove the two bolts fastening the idle speed controller to the intake manifold.
INSTALLATION
1. Position the idle speed controller on the intake manifold.
2. Install and tighten the two bolts retaining the idle speed controller to the intake manifold.
3. Install the hose from the intake duct to the idle speed controller.
4. Connect the idle speed controller electrical connector.
