Sportage 4WD L4-2.0L SOHC (1995)
7.
Loosen the screw clamps on the radiator cooler hoses and separate the cooler lines from the hoses.
8.
Remove the cooler lines from the vehicle.
9.
Remove the two (2) cooler line supports from the existing cooler lines and reinstall them on the new cooler lines in the same location.
10.
Position the new cooler lines into place by attaching one (1) cooler line support and clamp to the transmission housing and one (1) to the engine
block brackets.
* NOTICE
Do not tighten the clamp nuts at this time.
