Sportage 4WD V6-2.7L (2009)
The Kia Subframe Bushing Remover and Installer will need to
be configured according to the illustration for Removing The
Subframe Bushing.
1. Locate the 2 tabs on the bushing's flange and mark the
locations on the subframe.
2. Lift the assembly into place placing the rod through the
center of the bushing. Thread the nut on the top of the threaded
rod.
Line up the slots in the Installer/Remover Cup with the tabs on
the bushing. This will allow the cup to fit squarely over the
bushing.
Make sure the tool sets squarely around the bushing flange and
on the subframe.
Hand tighten the nuts until the assembly is held in place.
