Sportage 4WD V6-2.7L (2009)
Brake Master Cylinder: Overhaul
DISASSEMBLY
1. Remove the reservoir cap and drain the brake fluid into a suitable container.
2. Remove the fluid level sensor.
3. Remove the reservoir from the master cylinder, after remove mounting screw (A).
4. Remove the proportioning valves (A) - CBS only.
5. Remove the retainer ring by using the snap ring pliers then remove the primary piston assembly.
6. Remove the pin with the secondary piston pushed completely using a screwdriver. Remove the secondary piston assembly.
NOTE:
Do not disassemble the primary and secondary piston assembly.
REASSEMBLY