Sportage 4WD V6-2.7L (2009)
1. Insert the booster and tighten the nuts (C).
2. Connect the booster push rod and brake pedal with a pin (B) and install a snap pin (A) to the pin (B).
CAUTION:
Grease the pin before installing the snap pin.
Always use a new snap pin.
3. Install the master cylinder.
4. Connect the vacuum hose to the brake booster.
5. After filling the brake reservoir with brake fluid, bleed the system.
6. Check for fluid leakage.
7. Check and adjust the brake pedal for proper operation.
