Sportage 4WD 2Dr L4-2.0L (2002)
Engine Control Module: Service and Repair
Removal
1. Take out two screws and remove lower right side trim panel below the instrument panel, on the passenger side of the vehicle.
2. Pull back carpet to expose the ECM.
3. Remove four nuts retaining the ECM to the floorboard mounting bolts.
4. Remove the ECM from the mounting bolts.
5. Disconnect the ECM connector.
Installation
1. Attach the connector to the ECM.
2. Mount the ECM onto the mounting bolts in the floorboard.
3. Install four nuts to retain the ECM on the mounting bolts.
4. Put carpet back in place.
5. Hold trim panel in place and install the two retaining screws.