Sportage 4WD 2Dr L4-2.0L (2002)
Idle Speed/Throttle Actuator - Electronic: Service and Repair
Removal
1. Verify that the ignition switch is OFF.
2. Disconnect the IAC Valve connector.
3. Remove the two bolts fastening the IAC Valve to the air pipe.
4. Remove the IAC gasket.
5. Clean the mating surfaces of air pipe and IAC Valve.
Installation
1. Install a new gasket onto the IAC Valve.
2. Position the IAC Valve on the air pipe.
3. Install and tighten the two bolts retaining the IAC Valve to the air pipe.
4. Connect the IAC Valve electrical connector.
