Sportage 4WD 2Dr L4-2.0L (2002)
8. Connect fuel tank pressure sensor electrical connector.
9. Insert the ground wire and the fuel pump electrical connector wires through the access hole in the access door and mount it over the access hole.
10. Install four screws to secure the access door to the vehicle flooring.
11. Install the ground wire lug to the floor with the attaching screw.
12. Connect the two halves of the fuel pump assembly electrical connector.
13. Attach adhesive tape to any loose wiring and cover the area of the installed access door with the square of carpeting.
14. Release the catch for the rear seat and put it in the normal position.
15. Close the rear access door of the vehicle.
16. Connect the negative terminal to the battery.