Sportage 4WD 2Dr L4-2.0L (2002)
Installation
1. Reinstall the fuel tank pressure sensor to the fuel tank sending unit.
2. Reinstall the retainer nut.
3. Reinstall the fuel tank pressure sensor connector.
4. Reattach the fuel tank pressure sensor ground wire to the fuel tank sending unit mounting plate with the previously removed screw.
5. Reinstall the fuel pump access cover.
6. Reinstall the four screws to secure the access door to the vehicle flooring.
7. Install the ground wire lug to the floor with the attaching screw.
8. Connect the two halves of the fuel pump assembly electrical connector.
9. Attach adhesive tape to any loose wiring and cover the area of the installed access door with the square of carpeting.
10. Release the catch for the rear seat and put it in the normal position.
11. Close the rear access door of the vehicle.
12. Connect the negative terminal to the battery.
