Sportage EX 2WD L4-2.0L (1997)
2. Remove any cap or protective cover from the port on the top of the fuel tank.
3. Holding the assembled fuel pump/fuel sender assembly, guide it into the access port on the top of the fuel tank as far as it will go at that point.
*
NOTICE: Do not force fuel pump assembly parts. The fuel screen is delicate, and can be damaged by improper installation to the fuel tank.
4. While twisting very carefully and tilting the fuel pump assembly, push gradually on the assembly until it starts to go into position in the fuel tank
assembly.
5. Install eight screws around the top surface of the fuel pump assembly.
6. Connect the two fuel hose assemblies to the fuel pump assembly.
7. Install the two fuel hose clips to the two fuel hose assemblies connected to the fuel pump assembly.
8. Connect fuel tank pressure sensor electrical connector.
9. Insert the ground wire and the fuel pump electrical connector wires through the access hole in the access door and mount it over the access hole.
10. Install four screws to secure the access door to the vehicle flooring.
11. Install the ground wire lug to the floor with the attaching screw.
