Sportage EX 2WD L4-2.0L (1997)
4.
Disconnect the electrical connector from the ECM by first pivoting the locking handle down, then pivoting the electrical connector out of the ECM
from the wire harness end.
5.
Connect the electrical connector to the new ECM.
* NOTICE
Ensure that the electrical connector is fully seated into the ECM and the locking handle is latched.
6.
Position the ECM onto the mounting studs then re-install the two (2) right mounting nuts.
* NOTICE
Hand tighten the two (2) mounting nuts only at this time.
7.
Place a SC005 Campaign Completion Label onto the upper right corner of the new ECM cover.
