Sportage EX 2WD L4-2.0L (1997)
5. Put wheel bearing hub assembly on steering knuckle. Turn back and forth to verify correct bearing installation.
6. Screw lock nut up against wheel hub assembly and using a lock nut wrench, tighten nut to set bearing preload.
Bearing preload: 10 inch lbs. (1.3 Nm)
7. Put brake rotor on wheel bearing hub bolts and install the two retaining screws.
8. Mount dial indicator with plunger zeroed against brake rotor at 4.7 inch (12 cm) from rotor center.
9. Turn rotor and read dial indicator for runout dimension.
Runout not to exceed 0.004 inch (0.10 mm)
10. Install brake caliper and tighten two bolts.
