Sportage EX 2WD L4-2.0L (1997)
6. Using SST K95B-4200 AT3, compress the clutch piston return springs, then remove the shaft snap ring. Remove the SST, clutch return spring
retainer, and clutch return springs.
7. Install the O/D drum sub-assembly onto the oil pump. Apply air pressure into the fluid passage in the oil pump and remove the clutch piston.
NOTICE: Use a low pressure source (30 psi max) only.
8. Remove the piston inner O-ring and the piston outer O-ring from the clutch piston.
9. Remove the retaining ring from the O/D planetary gear set, then remove the O/D one-way clutch retainer, O/D one-way clutch, O/D one-way
clutch outer race, thrust washer and thrust bearing.
INSPECTION
