Sportage EX 2WD L4-2.0L (1997)
5. Measure the pinion bearing preload by turning the pinion with a torque wrench.
Pinion bearing preload: 10 inch lbs. (1.1 Nm)
Tighten nut to no more than 210 ft. lbs. (284 Nm), but not less than 94 ft. lbs. (128 Nm).
6. Remove the lock nut, washer, and companion flange.
7. Using SST K95U-0003-G and K95B-5003-D, install new oil seal.
8. Install companion flange, washer, and new lock nut.
9. Tighten lock nut.
Tighten nut to no more than 210 ft. lbs. (284 Nm), but not less than 94 ft. lbs. (128 Nm).
10. Measure run-out of the companion flange.
Maximum run-out: 0.0024 inch (0.06 mm)
Side Bearing
