landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Audio System - Speaker Vibration/Rattle Noise Diagnosis|Page 8291 > < Diagram Information and Instructions|Page 8278
Page 1
background image

Front Door Panel: Customer Interest
Audio System - Speaker Vibration/Rattle Noise Diagnosis

No: LRA415-001
Issue: 1
Date: 11 Sep 2006

SECTION: 415-03 - ENTERTAINMENT SYSTEM

Speaker Vibration or Rattle Noise Diagnosis

AFFECTED VEHICLE RANGE:

Land Rover Vehicles

CONDITION SUMMARY:

SPEAKER VIBRATION OR RATTLING NOISE DIAGNOSIS

Situation:
A customer may report a concern of a vibration noise or rattling sound from a speaker area. Various solutions are available to resolve the cause of the
reported noise.

This bulletin has been issued to provide Retailers with information and steps to correctly diagnose and resolve the reported noise.

Action:
Should a customer report a concern, verify that the noise is coming from an area near a speaker and refer to the steps outlined in the Repair Procedures
detailed in this bulletin to correctly diagnose the issue before replacing a speaker assembly. The information contained in the Repair Procedure section
should reduce the number of speaker assemblies that are being returned with "no fault found."

PARTS:

Refer to Microcat for the parts that are specific to the vehicle with the problem.

WARRANTY:

NOTE:

When reporting repairs under warranty for speaker related noise issues, only report under "audio" if the speaker has been replaced. For other
conditions and repairs report the issue under the appropriate trim area.

Normal warranty policy and procedures apply.

REPAIR PROCEDURE

1.

Identify the area of the reported noise.

2.

Check that the trim panels surrounding the speaker are correctly secured and not causing any vibration which is being attributed to the speaker.

3.

Check for any customer belongings in door pockets that could be causing the issue.

4.

Check the door casing mounted speaker cover/grills as follows:

^

Press and hold each grill in turn

^

Determine if the noise changes or stops.

^

If the noise does change or stops, check that the cover/grill is secured correctly to the door casing.

NOTE:

When submitting a claim for securing a speaker cover/grill, the claim should be logged as "trim" and not "audio".

5.

Properly secure the cover/grill where necessary.

6.

If the noise persists, remove the door casing and perform the following:

^

Check the speaker for any obvious physical damage such as dented cones, rips or tears in the speaker membrane.

Audio System - Speaker Vibration/Rattle Noise Diagnosis|Page 8291 > < Diagram Information and Instructions|Page 8278